Refinishing Wooden Floor Scratches

Refinishing wood floors is a great idea if you want to give them a whole new look. However, refinishing your floor can be complicated if it has received a lot of wear or scratches that are not easily removed. Refinishing wood can be very expensive if you need to completely replace the whole thing, and this could end up costing you more than buying a new wooden floor. In addition, refinishing your wood may cause the surface to become unsightly and may damage the entire appearance of the floor.

It is possible to remove dust and stains with a damp cloth, but there are times when this is not enough to remove the dirt and debris from your floor. When the dust and other materials are just sitting on the surface without being walked on, then there may be no need for a professional wooden floor refinishing. You can try using a little alcohol and water along with a dry cloth to remove the dirt. This method works well, but only if the floor is clean and dry. If you have an accident with mud or other debris on the floor, it may be necessary to call in a professional.

You can use the mixture of water and alcohol on your wooden floor to remove the stain from a scratch or gouge. Do not use this solution on a scratch that has simply been inflicted and is healing. This may cause the surface to become unsightly. Refinishing your wood flooring may be necessary if the surface has been scarred or gouged, and is done only by professionals.

Sanding your wooden floor will help remove the scratches as well as remove the dirt from the surface. If the scratches are quite deep, then you may need to use a power sander with high-speed sanding abilities. The high-speed sanding action will also speed up the drying time. It is important that you only use a solution that is meant for wooden floors or your efforts will waste money and time.

Refinishing your wooden floor should not be attempted unless you have taken the steps of sanding and cleaning your floor to remove all loose dirt, sand, and debris. Any protruding hardware should be removed. Next, your wooden floor should be stained with a sealer that is appropriate for its intended use. If you have any unfinished wood areas, do not apply the stain until the entire surface is properly prepared. If this is not accomplished correctly, the stain could leave a masking film on the area. Once the proper preparation has been done, you can begin your refinishing job.

To begin, take out all furniture from the room. Place a cloth over the floor and gently vacuum to remove the dust. After a brief period, the cloth will need to be replaced with a new one so that the surface is completely covered. Apply the first coat of stain using a sponge. Allow it to dry completely before moving on to the next. This may take up to an hour but the end result will greatly improve the appearance of your room.